Husqvarna Service information
Any material presented on this site, downloaded or in print form is intended for information purposes only. Any adjusting you do to your own sewing equipment is at your own risk.
Timing 2000 6000 series
Timing S2 drop-in bobbinInsert a new needle into the machine. Turn the hand wheel towards you until the needle is at the lowest position. Gently push the needle bar to the left (not all the way but almost). Some models you set the machine to the left position.
Slowly bring the needle up until the hook tip and needle meet. They should meet as shown above. The reason for this point is the thread is picked up by the hook from the scarf of the needle. If it picks up too high on the needle it will skip stitches on the right and if too low you will skip stitches on the left or center.
If timing adjustment is required, locate the timing adjustment bushing. Loosen the three screws on the bushing. The silver screw is a locking screw and has to be tightened last after the timing is done.
After the screws are loosened, carefully move the hook to match the picture above. Do not move the hook more than ½ turn as you may affect the feed timing. Tighten the screws starting with the two black screws. Recheck the timing.
Tension S2 drop-in
Tension 2000 6000 series
